8mtr CTEK D250SE 12V 20amp Dual DC-DC Battery to Battery Charger Kit with 70amp 10mm Cable
- Brands CTEK
- Product Code: D250SE/K8
- Availability: 10
-
£300.00
- Ex Tax: £250.00
8mtr CTEK D250SE 12V 20amp Dual DC-DC Battery to Battery Charger Kit with 70amp 10mm Cable
With award winning Swedish technology, the dual input D250SE which has now replaced the D250SA with added
connection to lithium batteries can draw its power from smart alternators and other DC sources, making it the ideal
charger for vehicles that don’t have access to a mains power supply. Its dual input capability means it can draw
power from solar and wind sources, in parallel to the alternator.
The D250SE is a fully automatic, 5 step charger that supplies up to 20A of power to charge, condition and
maintain any 12V lead acid service battery from 40-300Ah, including Wet, MF, Gel, AGM. EFB and Ca/Ca & lifepo4 Lithium.
The D250SE uses patented technology so it’s safe for you and your vehicle’s electronics. It’s also IP65 classified
(splash and dust proof, and suitable for outdoor use) and comes with a 2-year warranty.
You will be supplied with everything you need
1 x CTEK D250SE 20amp Charger
8mtrs 10mm² 70amp Red Battery Cable
2mtrs 10mm² 70amp Black Battery Cable
8mtrs 1.5mm² 15amp Red optional ignition cable
1 x Pair 8mm Post Type Battery Terminals
2 x Midi Fuse Holders + 4 x 30amp Midi Fuses
1 x Pack Terminals + Heat Shrink
10 x Cable tie bases
15 x cable ties 150mm
15 X 8x3/4 screws + 3mm HSS drill bit
2 x adhesive pads
8mtrs protective conduit to suit 10mm² cable
Wiring diagram
-
FASTER
CHARGING
-
-
The
D250SE automatically delivers the optimum charge so
your batteries are fully charged in the shortest possible time.
You
-
can
select normal or 14.7V AGM charge voltages. It also has
a temperature sensor to compensate for hot or cold conditions
and
-
avoid
the risk of your battery overheating or overcharging.
-
-
DIRECT
CONNECTION FOR SOLAR POWER
-
The
D250SE has an input for connecting solar panels without the
need for a regulator. It also features a Maximum Power
-
Point
Tracker (MPPT) to get the maximum power out of your solar
panels.
-
-
SMART
ALTERNATOR COMPATIBILITY
-
Vehicle
manufacturers are now introducing smart ECU (Engine Control
Unit) controlled alternators to increase fuel efficiency
-
and
lower emissions. Smart alternators deliver a variable out-put and
are shut off when they’re not needed.
-
The
D250SE will still operate even if the smart alternator is shut
off and maintain a stable output of up to 20A to fully
-
charge
your battery in the shortest time.
FEATURES
• 5 step charging from smart and conventional alternators and DC sources, such as solar and wind
• Automatic battery separator works without the need for diodes or VSR relays
• Selectable AGM mode for AGM batteries
• Parallel input from both alternator and solar panel
• Solar panel regulator with Maximum Power Point Tracking (MPPT)
• Starter battery maintenance charging when your service battery is fully charged
Pleaseclick HERE for Data Sheet
Pleaseclick HERE for wiring guide
Additional Solar Panel MPPT Information for Ctek D250SE
Max open circuit voltage from panel is only 23v
A higher voltage will damage the charger and will invalidate warranty